2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

Cruise Main Indicator Light Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

  1. When the ECM detects a cruise control switch on signal from the cruise control switch, it sends it to the combination meter assembly through CAN communication. Then the cruise control indicator light turns on.
  2. The cruise control indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Select the item below in the Active Test, and then check that the cruise control indicator light illuminates (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Cruise
    Cruise control indicator light
    ON/OFF
    -

    OK:
    Cruise control indicator light turns on/off.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2. READ VALUE USING INTELLIGENT TESTER
  1. Use the Data List to check if the cruise control switch is functioning properly (Click here).

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Main SW M-CPU
    Cruise control switch (Main CPU) / ON or OFF
    ON: Cruise control switch on
    OFF: Cruise control switch off
    -

    OK:
    On screen, each item changes between ON and OFF according to above chart.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1GR-FE)
    B
    NG (for 2TR-FE)
    C
    NG (for 1KD-FTV)
    D



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Cruise Control Switch Circuit (from Aug 2014)Cruise Main Indicator Light Circuit (from Aug 2014) →