2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

P1617 Distance Control ECU Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2013

DESCRIPTION

In the dynamic radar cruise control system, the ECM and driving support ECU communicate with one another to control the system based on certain designation information. If the designation information of the ECM and driving support ECU are different or the driving support ECU is malfunctioning, this DTC is stored.
DTC Code
DTC Detection Condition
Trouble Area
P1617
While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, a designation signal from the ECM and a designation return signal from the driving support ECU do not match or the driving support ECU is malfunctioning for 1 second.
  1. Driving support ECU
  2. ECM

INSPECTION PROCEDURE

NOTICE:
When the driving support ECU or ECM is replaced with a new one, initialization must be performed (Click here).


1. CONFIRM DESIGNATION INFORMATION
  1. Confirm the designation information.

    1. Turn the ignition switch to ON.

    2. Turn the cruise control switch on.

    3. With the brake pedal depressed, push the cruise control switch to +RES 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.

      OK:
      The skid control buzzer sounds (initialization is performed).

      NOTICE:
      1. Do not turn the light control switch on at this time as doing so causes the beam axis to deviate. If the light control switch is turned on by mistake, readjust the beam axis (Click here).
      2. If initialization cannot be performed, first inspect the stop light switch circuit, cruise control switch circuit and skid control buzzer circuit.

    4. Turn the ignition switch off.


NEXT


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of 50 km/h (31 mph) or more.

    2. Turn the cruise control switch on.

  1. Check for DTCs (Click here).

    OK:
    DTC P1617 is not output.



NG
Go to step 3
OK

END

3. REPLACE DRIVING SUPPORT ECU
  1. Replace the driving support ECU (Click here).


NEXT


4. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of 50 km/h (31 mph) or more.

    2. Turn the cruise control switch on.

  1. Check for DTCs (Click here).

    OK:
    DTC P1617 is not output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1GR-FE)
    B
    NG (for 1KD-FTV)
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

END (DRIVING SUPPORT ECU IS DEFECTIVE)


← P1616 Communication Error from ECM to Distance Control ECU (from Aug 2013)P1630 Communication Error from VSC to ECM (from Aug 2013) →