2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

P1575 Warning Buzzer Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the skid control ECU detects a malfunction in the skid control buzzer circuit, a malfunction signal is sent to the ECM and a DTC is stored.
DTC Code
DTC Detection Condition
Trouble Area
P1575
While the vehicle speed is 50 km/h (31 mph) or more with the cruise control switch on, a skid control buzzer circuit malfunction signal is received from the skid control ECU for 1 second.
  1. Vehicle stability control system
  2. ECM

INSPECTION PROCEDURE

NOTICE:
When the ECM is replaced with a new one, initialization must be performed (Click here).


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Select the item below in the Active Test, and then check that the skid control buzzer sounds (Click here).

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    ON/OFF
    -

    OK:
    Skid control buzzer sounds.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of 50 km/h (31 mph) or more.

    2. Turn the cruise control switch on.

  1. Check for DTCs (Click here).

    OK:
    DTC P1575 is not output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1GR-FE)
    B
    NG (for 1KD-FTV)
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← P1572 Improper Aiming of Radar Sensor Beam Axis (from Aug 2013)P1575 Warning Buzzer Malfunction (from Aug 2014) →