2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

Wiper Signal Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the driving support ECU detects that the wipers are operating at high speed, the dynamic radar cruise control system is canceled.

WIRING DIAGRAM

E200952E09

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK WINDSHIELD WIPER SWITCH ASSEMBLY

  1. E285051E02
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (+2) - Body ground*1
    9 (+2) - Body ground*2
    Ignition switch ON, windshield wiper switch Hi
    11 to 14 V
    Ignition switch ON, windshield wiper switch Lo
    Approximately 9 V
    Ignition switch ON, windshield wiper switch off
    Below 1 V

    1. *1: for LH Side
    2. *2: for RH Side
    Text in illustration 
    *A
    for RH Side
    *B
    for LH Side
    *a
    Component with harness connected
    (Windshield Wiper Switch Assembly)



NG
REPLACE WINDSHIELD WASHER SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (WINDSHIELD WASHER SWITCH - DRIVING SUPPORT ECU)
  1. Disconnect the G119 ECU connector.

  1. Disconnect the G120 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G119-32 (WIP2) - G120-1 (+2)*1
    Always
    Below 1 Ω
    G119-32 (WIP2) - G120-9 (+2)*2
    G119-32 (WIP2) - Body ground
    Always
    10 kΩ or higher

    1. *1: for LH Side
    2. *2: for RH Side



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Wiper Signal Circuit (Aug 2013 – Jul 2014)Cruise Main Indicator Light Circuit (Aug 2013 – Jul 2014) →