PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| Cruise control switch cannot be turned on (Cruise control indicator light in combination meter assembly does not illuminate) |
Cruise control switch circuit |
Click here
|
| ECU power source circuit |
Click here
|
|
| Cruise main indicator light circuit |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Driving support ECU |
Click here
|
|
| Vehicle-to-vehicle distance cannot be changed with distance control switch |
Distance control switch circuit |
Click here
|
| Driving support ECU |
Click here
|
|
| System cannot be changed to constant speed mode |
Cruise control switch circuit |
Click here
|
| CAN communication system (for LHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Combination meter assembly |
Click here
|
|
| System cannot be changed to vehicle-to-vehicle distance control mode |
Millimeter wave radar sensor power source circuit |
Click here
|
| Millimeter wave radar sensor assembly |
Click here
|
|
| Cruise control switch circuit |
Click here
|
|
| CAN communication system (for LHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Driving support ECU |
Click here
|
|
| Combination meter assembly |
Click here
|
|
| During constant speed mode operation, system operation is canceled |
Cruise control switch circuit |
Click here
|
| Park/neutral position switch |
Click here
|
|
| Stop light switch circuit |
Click here
|
|
| CAN communication system (for LHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| During vehicle-to-vehicle distance control mode operation, system operation is canceled |
Millimeter wave radar sensor power source circuit |
Click here
|
| Millimeter wave radar sensor assembly |
Click here
|
|
| Cruise control switch circuit |
Click here
|
|
| Park/neutral position switch |
Click here
|
|
| Wiper signal circuit |
Click here
|
|
| Stop light switch circuit |
Click here
|
|
| CAN communication system (for LHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Driving support ECU |
Click here
|
|
| Shift lever cancel operation does not operate |
Park/neutral position switch |
Click here
|
| CAN communication system (for LHD with Entry and Start System) [for 1KD-FTV] |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) [for 1KD-FTV] |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) [for 1KD-FTV] |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) [for 1KD-FTV] |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Transmission control ECU assembly (for 1KD-FTV) |
Click here
|
|
| Low speed limit cancel operation does not operate |
CAN communication system (for LHD with Entry and Start System) |
Click here
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| Skid control ECU (for LHD) |
Click here
|
|
| Skid control ECU (for RHD) |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| During vehicle-to-vehicle distance control mode, wiper cancel operation does not operate |
Wiper signal circuit |
Click here
|
| CAN communication system (for LHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Driving support ECU |
Click here
|
|
| Even though millimeter wave radar sensor is not dirty, "CLEAN RADAR SENSOR" is displayed |
Millimeter wave radar sensor radiator grille is dirty |
- |
| CAN communication system (for LHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Combination meter assembly |
Click here
|
|
| Driving support ECU |
Click here
|
|
| No information on multi-information display |
CAN communication system (for LHD with Entry and Start System) |
Click here
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| Combination meter assembly |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Beam axis of millimeter wave radar sensor assembly cannot be adjusted |
Check installation millimeter wave radar sensor assembly |
Click here
|
| Millimeter wave radar sensor assembly |
Click here
|
|
| Driving support ECU |
Click here
|
|
| Alarm buzzer does not sound |
Skid control buzzer circuit |
Click here
|
| Millimeter wave radar sensor assembly |
Click here
|
|
| CAN communication system (for LHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| Combination meter assembly |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Driving support ECU |
Click here
|
|
| No brake control (when decelerating) |
Vehicle stability control system |
Click here
|
| CAN communication system (for LHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Driving support ECU |
Click here
|
|
| Cruise control SET indicator light does not come on (SET function operates normally) |
Cruise SET indicator light |
Click here
|
| CAN communication system (for LHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for LHD without Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD with Entry and Start System) |
Click here
|
|
| CAN communication system (for RHD without Entry and Start System) |
Click here
|
|
| Combination meter assembly |
Click here
|
|
| ECM (for 1GR-FE) |
Click here
|
|
| ECM (for 1KD-FTV) |
Click here
|
|
| Driving support ECU |
Click here
|