2013-2015 Land Cruiser Prado · Service Manual Brake

C1340 Center Differential Lock Circuit

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
C1340
An open circuit is detected in the EXI circuit of the skid control ECU.
  1. Harness or connector
  2. Transfer system
  3. Master cylinder solenoid (Skid control ECU)

WIRING DIAGRAM

C212548E03

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. CHECK TERMINAL VOLTAGE (EXI)
  1. Disconnect the A7 skid control ECU connector.

  1. C214161E29
    Measure the voltage according to the value(s) in the table below.
    Standard Voltage 
    Tester Connection
    Switch Condition
    Specified Condition
    A7-27 (EXI) - Body ground
    Ignition switch ON
    11 to 14 V
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU)



NG
Go to step 3
OK


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)

3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - FOUR WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR)
  1. Disconnect the A7 skid control ECU (master cylinder solenoid) connector.

  1. Disconnect the G53 4 wheel drive control ECU connector.

  1. Disconnect the C43 center differential lock detection switch (transfer shift actuator assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A7-27 (EXI) - G53-14 (P1)
    Always
    Below 1 Ω
    A7-27 (EXI) - C43-9 (CDL)
    Always
    Below 1 Ω
    A7-27 (EXI) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)


← C1337 Diameter of the Tire is not Uniform (from Aug 2014)C1340 Center Differential Lock Circuit (from Aug 2014) →