C1340 Center Differential Lock Circuit
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1340 |
An open circuit is detected in the EXI circuit of the skid control ECU. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform calibration (Click here).
| 1. CHECK TERMINAL VOLTAGE (EXI) |
Disconnect the A7 skid control ECU connector.
Measure the voltage according to the value(s) in the table below.

Standard Voltage Tester Connection
Switch Condition
Specified Condition
A7-27 (EXI) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Skid Control ECU)
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output (for LHD)
B
DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - FOUR WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR) |
Disconnect the A7 skid control ECU (master cylinder solenoid) connector.
Disconnect the G53 4 wheel drive control ECU connector.
Disconnect the C43 center differential lock detection switch (transfer shift actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A7-27 (EXI) - G53-14 (P1)
Always
Below 1 Ω
A7-27 (EXI) - C43-9 (CDL)
Always
Below 1 Ω
A7-27 (EXI) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
