Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)
C1282 Center Differential Lock Position Switch
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
DTC C1282 is stored only in test mode.
DTC Code
DTC Detection Condition
Trouble Area
C1282
Stored during test mode.
Harness or connector
Transfer system
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform calibration (Click here ).
1. CHECK DTC
Check for DTCs (Click here ).
Result
Result
Proceed to
DTC C1340 is not output
A
DTC C1340 is output
B
B
A
2. CHECK TEST MODE DTC
Switch the vehicle to test mode, perform the center differential lock signal check, and then check that the Test Mode (Signal Check) DTC C1282 is cleared (Click here ).
Result
Result
Proceed to
Test Mode DTC C1282 is not cleared
A
Test Mode DTC C1282 is cleared
B
B
A
3. CHECK HARNESS AND CONNECTOR (MASTER CYLINDER SOLENOID - 4 WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR ASSEMBLY)
Disconnect the A7 skid control ECU (master cylinder solenoid) connector.
Disconnect the G53 4 wheel drive control ECU connector.
Disconnect the C43 center differential lock detection switch (transfer shift actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
A7-27 (EXI) - G53-14 (P1)
Always
Below 1 Ω
A7-27 (EXI) - C43-9 (CDL)
Always
Below 1 Ω
A7-27 (EXI) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here )