2013-2015 Land Cruiser Prado · Service Manual Brake

C1268 Transfer L4 Position Switch Circuit

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
C1268
The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via CAN.
  1. Transfer system
  2. Master cylinder solenoid (Skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. INSPECT TRANSFER L4 SHIFT
  1. Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.

    OK:
    There are no problems with the transfer system.



NG
GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)
OK


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Shift the transfer to L4, drive the vehicle, and then check for DTCs.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1268 Transfer L4 Position Switch Circuit (Aug 2013 – Jul 2014)C1282 Center Differential Lock Position Switch (Aug 2013 – Jul 2014) →