2013-2015 Land Cruiser Prado · Service Manual Brake

C120A ECU Initial Setting Incomplete

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The master cylinder solenoid (skid control ECU) records information on whether there is a kinetic dynamic suspension system or not.
w/ Downhill Assist Control or w/ Crawl Control:
When the master cylinder solenoid (skid control ECU) is replaced, the master cylinder solenoid (skid control ECU) must be informed that the vehicle is equipped with downhill assist control and/or crawl control.
DTC Code
DTC Detection Condition
Trouble Area
C120A
Either condition is met:
  1. The master cylinder solenoid is not informed that the vehicle is equipped with downhill assist control or crawl control and downhill assist control or crawl control operates.
  2. There is no information on whether there is a kinetic dynamic suspension system or not.
Calibration not performed

INSPECTION PROCEDURE


1. PERFORM CALIBRATION
  1. Perform calibration (Click here).

    NOTICE:
    If a DTC is output after replacing the master cylinder solenoid, it is possible that calibration has not been performed or the zero point calibration data was not cleared when calibration was performed.


NEXT


2. CHECK DTC
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A


3. CHECK TEST MODE DTC
  1. Switch the vehicle to test mode, perform the downhill assist control switch or crawl switch signal check, and then check that Test Mode (Signal Check) DTC C1379 is cleared (Click here).

    Result 
    Result
    Proceed to
    Test Mode DTC C1379 is not cleared
    A
    Test Mode DTC C1379 is cleared
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO DTC C1379 (Click here)


← C1203 ECM Communication Circuit Malfunction (from Aug 2014)C120A ECU Initial Setting Incomplete (from Aug 2014) →