C15F0 VFC Solenoid Circuit
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This circuit supplies electric power to the power steering solenoid valve.The power steering ECU controls the output current to the power steering solenoid valve in accordance with the steering angle signal, steering zero point memory, vehicle speed signal and engine speed signal, adjusting the amount of power steering assist.
| DTC Code |
DTC Detection Condition |
Trouble area |
| C15F0 |
A short or open in the solenoid valve circuit |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING GTS (SOLENOID CURRENT) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / PPS / Data List.
PPS Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Solenoid Current
Solenoid Current/
Min.: 0 mA
Max.: 1000 mA
200 to 950 mA
The engine is running and the steering wheel is being turned.
- OK:
- The normal condition value is displayed the GTS.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - POWER STEERING SOLENOID VALVE) |
Disconnect the power steering ECU and power steering solenoid valve connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G46-7 (SOF+) - C38-2 (SOF+)
Always
Below 1 Ω
G46-8 (SOF-) - C38-1 (SOF-)
G46-7 (SOF+) - Body ground
Always
10 kΩ or higher
G46-8 (SOF-) - Body ground
|
|
||||
| OK | |
| 3. INSPECT POWER STEERING SOLENOID VALVE ASSEMBLY |
![]() ![]() |
Disconnect the power steering solenoid valve connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 (SOF-) - 2 (SOF+)
20°C (68°F)
6.7 to 7.3 Ω
Connect the battery positive (+) lead with a 21 W bulb to terminal 2 (SOF+) and the negative (-) lead to terminal 1 (SOF-) of the solenoid valve connector. Then check that the valve moves and makes an operating noise.
- OK:
- Valve moves and makes an operating noise.
| *a |
Component without harness connected (Power Steering Solenoid Valve) |
| Result |
Proceed to |
| OK |
A |
| NG (for 1GR-FE) |
B |
| NG (for 1KD-FTV) |
C |
| NG (for 2TR-FE) |
D |
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||

