2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
3.
REMOVE REAR FLOOR MAT SUPPORT PLATE
Remove the 5 screws.
Detach the 6 claws and remove the rear floor mat rear support plate.
4.
REMOVE REAR FLOOR SERVICE HOLE COVER
HINT:
Fold back the floor mat so that the rear floor service hole cover can be removed.
Remove the 3 screws and rear floor service hole cover.
Disconnect the fuel sender gauge connector and fuel pump connector.
5.
REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY
Remove the 5 bolts and No. 1 fuel tank protector.
6.
DRAIN FUEL
Remove the fuel tank drain plug and gasket and drain the fuel.
Install a new gasket and the fuel tank drain plug.