2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2013

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE REAR SEAT ASSEMBLY LH
  1. Remove the rear seat assembly LH (Click here).


2. REMOVE REAR SEAT UPPER RECLINING COVER LH

B237615E01
  1. Using a screwdriver, detach the 3 claws and remove the rear seat upper reclining cover LH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

B237616
  1. Remove the 3 screws and reclining adjuster release handle LH.


4. REMOVE CENTER SEAT HINGE COVER LH

B237617
  1. Using a clip remover, remove the clip.

  1. Detach the 2 guides and remove the center seat hinge cover LH.


5. REMOVE REAR SEAT CUSHION MOULDING LH

B237619
  1. Using a clip remover, detach the clip.

  1. Using a moulding remover, detach the 3 claws.

  1. Move the rear seat cushion moulding LH in the direction of the arrow to detach the guide and remove the rear seat cushion moulding LH.


6. REMOVE REAR SEATBACK LOCK STRIKER COVER LH

B237621
  1. Using a clip remover, detach the 3 clips and remove the rear seatback lock striker cover LH.


7. REMOVE SEAT CUSHION COVER WITH PAD

  1. B359313
    w/ Seat Heater System:

    1. Disconnect the 2 rear seat heater connectors.

    2. B360133
      Pull out the wire harness as shown in the illustration.

  1. B237622
    Detach the hooks.

  1. B237624
    Detach the hook and remove the seat cushion cover with pad.


8. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY LH

B237670
  1. Remove the bolt and inner belt and disconnect the 3 point type belt anchor.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →