2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE AIR SWITCHING VALVE ASSEMBLY
(Click here)

2. REMOVE FRONT FENDER APRON SEAL RH

  1. C214927
    Remove the 5 clips and front fender apron seal RH.


3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector and detach the wire harness clamp.

  1. Disconnect the heated oxygen sensor connector and detach the wire harness clamp.

  1. Remove the 4 bolts and 2 compression springs.

  1. Disconnect the exhaust pipe support to remove the front exhaust pipe assembly.

  1. Remove the 2 gaskets.


4. REMOVE MANIFOLD STAY

  1. C214941
    Remove the 3 bolts and manifold stay.


5. REMOVE EXHAUST MANIFOLD

  1. C213690
    Remove the 8 nuts and exhaust manifold.

  1. Remove the gasket.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →