Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE)
L4 Position Switch Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The four wheel drive control ECU judges whether the transfer is in the L4 position based on the information from the limit switch inside the transfer shift actuator assembly which is detected by the ECM. The four wheel drive control ECU then inputs a signal to the combination meter assembly via CAN communication and turns on the 4LO indicator. WIRING DIAGRAM
Refer to DTC P2772 (Click here ). INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)
Disconnect the G53 four wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
G53-21 (L4) - Body ground
Always
10 kΩ or higher
Text in Illustration
*a
Front view of wire harness connector (to Four Wheel Drive Control ECU)
NG
OK
2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - ECM)
Disconnect the G55 ECM connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
G55-16 (L4) - Body ground
Always
10 kΩ or higher
Text in Illustration
*a
Rear view of wire harness connector (to ECM)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK