2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Result of CAN V1 Bus Check 
Symptom
Suspected Area
See page
Result of "How to proceed with Troubleshooting" is "Open in CAN Main Wire"
Open in CAN Main Wire
Click here
Result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines"
Short in CAN Bus Lines
Click here
Result of "How to Proceed with Troubleshooting" is "Short to B+ in CAN Bus Line"
Short to B+ in CAN Bus Line
Click here
Result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line"
Short to GND in CAN Bus Line
Click here
Result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line"
Open in One Side of CAN Branch Line
Click here

HINT:
Refer to How to Proceed with Troubleshooting for the CAN V1 Bus Check procedure.

Communication Stop Mode Table  
Symptom
Suspected Area
See page
"Skid Control (ABS/VSC/TRAC)" is not displayed on the intelligent tester
Brake Actuator (Skid Control ECU) Communication Stop Mode
Click here
"PPS" is not displayed on the intelligent tester
Power Steering ECU Communication Stop Mode
Click here
"Spiral cable (Steering Angle Sensor)" is not displayed on the intelligent tester
Steering Angle Sensor Communication Stop Mode
Click here
"Yaw Rate Sensor" is not displayed on the intelligent tester
Yaw Rate Sensor Communication Stop Mode
Click here
"ECM (Engine)" is not displayed on the intelligent tester
ECM Communication Stop Mode
Click here
"Main Body" is not displayed on the intelligent tester
Main Body ECU Communication Stop Mode
Click here
"Power Management1" is not displayed on the intelligent tester
Power Management Control ECU Communication Stop Mode
Click here
"Combination Meter" is not displayed on the intelligent tester
Combination Meter ECU Communication Stop Mode
Click here
"Certification (Smart)" is not displayed on the intelligent tester
Certification ECU Communication Stop Mode
Click here
"Airbag" is not displayed on the intelligent tester
Center Airbag Sensor Communication Stop Mode
Click here
"Four Wheel Drive Control" is not displayed on the intelligent tester
4WD Control ECU Communication Stop Mode
Click here
"Display and Navigation (AVN1)" is not displayed on the intelligent tester*1
Navigation ECU Communication Stop Mode
Click here
"Display and Navigation (AVN1)" is not displayed on the intelligent tester*2
Audio Receiver Assembly Communication Stop Mode
Click here
  1. *1: w/ Navigation System (for Navigation Receiver Type)
  2. *2: w/ Navigation System (for Radio and Display Type) or w/o Navigation System
← HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014)PROBLEM SYMPTOMS TABLE (from Aug 2014) →