2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL NO. 2 GLOW PLUG CONTROLLER BRACKET
  1. Install the No. 2 glow plug controller bracket to the glow plug controller with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


2. INSTALL NO. 1 GLOW PLUG CONTROLLER BRACKET
  1. Install the No. 1 glow plug controller bracket to the glow plug controller with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


3. INSTALL GLOW PLUG CONTROLLER
  1. Install the glow plug controller with the 2 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 4 connectors and clamp.


4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
  1. Install the front fender splash shield sub-assembly with 12 new grommets.

  1. Install the 2 screws and bolt.


5. INSTALL FRONT FENDER MUDGUARD LH
  1. Install the front fender mudguard with the 4 screws and 2 clips.


6. INSTALL FRONT WHEEL LH

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSTALLATION (Aug 2013 – Jul 2014)COMPONENTS (from Aug 2013) →