2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1AB7 Blind Spot Monitor Slave Module

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects an internal malfunction.
DTC Code
DTC Detection Condition
Trouble Area
C1AB7
The blind spot monitor sensor RH (slave) detects an internal malfunction.
Blind spot monitor sensor RH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← C1AB7 Blind Spot Monitor Slave Module (Aug 2013 – Jul 2014)C1AB8 Destination Information Undefined (Aug 2013 – Jul 2014) →