C1AB8 Destination Information Undefined
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor has been replaced.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1AB8 |
The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU). |
|
INSPECTION PROCEDURE
- NOTICE:
- When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for CAN Communication System DTCs.
- for LHD with Entry and Start System: Click here
- for LHD without Entry and Start System: Click here
- for RHD with Entry and Start System: Click here
- for RHD without Entry and Start System: Click here
Result Result
Proceed to
OK
A
NG (for LHD with Entry and Start System)
B
NG (for LHD without Entry and Start System)
C
NG (for RHD with Entry and Start System)
D
NG (for RHD without Entry and Start System)
E
- for LHD with Entry and Start System: Click here
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | |
| 2. REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
Replace the main body ECU (multiplex network body ECU) with a new or normally functioning one.
| NEXT | |
| 3. CHECK DTC |
Recheck for DTCs and check if the same DTC is output again (Click here).
Result Result
Proceed to
No DTC is output
A
DTC is output from the blind spot monitor sensor LH (master)
B
DTC is output from the blind spot monitor sensor RH (slave)
C
|
|
||||
|
|
||||
| A | ||
| ||
