2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1AB8 Destination Information Undefined

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor has been replaced.
DTC Code
DTC Detection Condition
Trouble Area
C1AB8
The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU).
  1. CAN communication system
  2. Main body ECU (multiplex network body ECU)
  3. Blind spot monitor sensor LH
  4. Blind spot monitor sensor RH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check for CAN Communication System DTCs.

    1. for LHD with Entry and Start System: Click here
    2. for LHD without Entry and Start System: Click here
    3. for RHD with Entry and Start System: Click here
    4. for RHD without Entry and Start System: Click here
    Result 
    Result
    Proceed to
    OK
    A
    NG (for LHD with Entry and Start System)
    B
    NG (for LHD without Entry and Start System)
    C
    NG (for RHD with Entry and Start System)
    D
    NG (for RHD without Entry and Start System)
    E



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (Click here)

E
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2. REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
  1. Replace the main body ECU (multiplex network body ECU) with a new or normally functioning one.


NEXT


3. CHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    Result 
    Result
    Proceed to
    No DTC is output
    A
    DTC is output from the blind spot monitor sensor LH (master)
    B
    DTC is output from the blind spot monitor sensor RH (slave)
    C



B
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
A

END (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] IS DEFECTIVE)


← C1AB8 Destination Information Undefined (Aug 2013 – Jul 2014)C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (Aug 2013 – Jul 2014) →