C2198/98 Initialization Switch (for Test Mode DTC)
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C2198/98 |
Test mode procedure is performed. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
- It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
- When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
| 1. INSPECT TIRE PRESSURE WARNING RESET SWITCH |
Remove the tire pressure warning reset switch (Click here).
Inspect the tire pressure warning reset switch (Click here).
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER) |
Disconnect the tire pressure warning reset switch G153 connector and the tire pressure warning ECU and receiver R41 connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R41-7 (CLSW) - G153-1
Always
Below 1 Ω
R41-7 (CLSW) or G153-1 - Body ground
Always
10 kΩ or higher
G153-2 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
