2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1AB5 Open in Outer Mirror Indicator(Slave)

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects an open in the blind spot monitor indicator RH.
DTC Code
DTC Detection Condition
Trouble Area
C1AB5
With the blind spot monitor main switch assembly (multi-function switch) on, the current flowing to the indicator is below a specified value when indicator operation voltage is sent to the indicator.
  1. Harness or connector
  2. Outer rear view mirror sub-assembly RH
  3. Outer rear view mirror assembly RH
  4. Blind spot monitor sensor RH

WIRING DIAGRAM

E221720E13

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR ASSEMBLY RH - BLIND SPOT MONITOR SENSOR RH AND BODY GROUND)
  1. Disconnect the R43 blind spot monitor sensor RH connector.

  1. Disconnect the J3 outer rear view mirror assembly RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R43-4 (OMIR) - J3-2 (BSR+)
    Always
    Below 1 Ω
    J3-2 (BSR+) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK OUTER REAR VIEW MIRROR SUB-ASSEMBLY RH
  1. Replace the outer rear view mirror sub-assembly RH with a new or normally functioning one (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 4
OK

END (OUTER REAR VIEW MIRROR SUB-ASSEMBLY RH IS DEFECTIVE)

4. CHECK OUTER REAR VIEW MIRROR ASSEMBLY RH
  1. Replace the outer rear view mirror assembly RH with a new or normally functioning one (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
OK

END (OUTER REAR VIEW MIRROR ASSEMBLY RH IS DEFECTIVE)


← C1AB5 Open in Outer Mirror Indicator(Slave) (Aug 2013 – Jul 2014)C1AB6 Blind Spot Monitor Master Module (Aug 2013 – Jul 2014) →