Refer to DTC P0335 (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>P0335).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0016 | Deviations in the crankshaft and camshaft position sensor 1 signals (2 trip detection logic). | ·
Valve timing ·
Camshaft timing oil control valve assembly ·
Oil control valve assembly filter ·
Camshaft timing gear assembly ·
ECM |
| P0018 | Deviations in the crankshaft and camshaft position sensor 2 signals (2 trip detection logic). |
Refer to DTC P0335 (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>P0335).
Refer to DTC P0340 (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>P0340).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| P0016 or P0018 | A |
| P0016 or P0018 and other DTCs | B |
A
B
Connect the GTS to the DLC3.
Start the engine and turn the GTS on.
Warm up the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 1) or Control the VVT System (Bank 2).
Check the engine speed while operating the camshaft timing oil control valve assembly using the GTS.
| GTS Operation | Specified Condition |
|---|---|
| OCV OFF | Normal engine speed |
| OCV ON | Engine idles roughly or stalls soon after camshaft timing oil control valve assembly switched from off to on |
OK
NG
Check the engine mechanical system (See page Engine / Hybrid System>1GR-FE (ENGINE MECHANICAL)>ENGINE UNIT>INSPECTION).
NEXT
OK
NG
OK
NG
Replace the camshaft timing gear assembly (See page Engine / Hybrid System>1GR-FE (ENGINE MECHANICAL)>CAMSHAFT>REMOVAL).
Perform "Inspection After Repair" after replacing the camshaft timing gear assembly (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION).
NEXT
In order to clear the ECM learned values for valve timing, disconnect the cable from the negative (-) battery terminal for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Clear the DTCs (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR).
Start the engine and idle it for 5 minutes.
Drive the vehicle in an urban area for approximately 10 minutes.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
Read the DTCs.
DTCs are not output.
OK
NG