Home › Engine / Hybrid System › 5L-E (ENGINE CONTROL) › DIESEL THROTTLE BODY
RM27T0E _51 Engine / Hybrid System _053658 5L-E ENGINE CONTROL _0260437 DIESEL THROTTLE BODY A

5L-E ENGINE CONTROL  DIESEL THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 26100 1.INSTALL DIESEL THROTTLE BODY

a.

Place a new gasket and the diesel throttle body on the intake manifold.


b.

Connect the throttle control motor connector.


c.

Connect the throttle open switch connector.


Hide 17114A 2.INSTALL INTAKE FLANGE

a.

Install a new gasket and the intake flange with the 3 nuts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


b.

Connect the PCV hose.


c.

Connect the manifold absolute pressure sensor connector.


d.

Connect the heater water hose with the bolt.

Torque:
14 N*m (138 kgf*cm, 10 ft.*lbf)


Hide 17130 3.INSTALL INTAKE PIPE

a.

Install the intake pipe with the 2 bolts and tighten the hose clamp.

Torque:
for bolt : 18 N*m (184 kgf*cm, 13 ft.*lbf)
for clamp : 6.0 N*m (61 kgf*cm, 53 in.*lbf)


Hide 17705 4.INSTALL RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY