The crankshaft position sensor in the engine control system contains a signal plate and a pickup coil for the TDC signal. The TDC signal plate has 1 tooth on its outer circumference. The TDC signal sensor generates 1 signal for every engine revolution. The ECM detects the top dead center by the TDC signals.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0340 | No TDC signal to ECM at 400 rpm or more. | ·
Open or short in crankshaft position sensor circuit ·
Crankshaft position sensor ·
ECM |
Refer to DTC P0335 (See page Engine / Hybrid System>5L-E (ENGINE CONTROL)>ECD SYSTEM>P0335).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Check the crankshaft position sensor installation.
Inspect the crankshaft position sensor.
OK
NG
Disconnect the crankshaft position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C109-1 - C162-26 (TDC+) | Always | Below 1 Ω |
| C109-2 - C162-34 (TDC-) | Always | Below 1 Ω |
| C109-1 or C162-26 (TDC+) - Body ground | Always | 10 kΩ or higher |
| C109-2 or C162-34 (TDC-) - Body ground | Always | 10 kΩ or higher |
OK
NG