An nitrogen oxides sensor is installed in front exhaust pipe assembly, in order to detects the concentration of NOx and O2 in the exhaust gas.
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
|---|---|---|
| Engine switch on (IG) for 3 seconds or more | An open or short circuit occurs in the nitrogen oxides sensor circuit for 3 seconds or more.
(1 tripdetection logic) |
Nitrogen oxides sensor |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
|---|---|---|
| Engine switch on (IG) for 3 seconds or more | An open or short circuit occurs in the nitrogen oxides sensor circuit for 3 seconds or more.
(1 tripdetection logic) |
Nitrogen oxides sensor |
| DTC No. | Data List |
|---|---|
| P2200
P220E |
NOx Density B1S1 |
Refer to DTC U029D (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>U029D).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P2200, P220E is output | A |
| DTC P2200 or P220E and other DTCs are output* | B |
*: If any other DTCs are output, perform troubleshooting for those DTCs first.
A
B
Replace the nitrogen oxides sensor (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>NITROGEN OXIDES SENSOR>REMOVAL).
NEXT
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Clear the DTCs (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>DTC CHECK / CLEAR).
Engine switch on (IG) for 3 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Confirm that the DTC is not output again.
NEXT