In order to detect blockages in the positive pressure filter, the ECM determines if the fuel pressure of the common rail has deviated from the target value every 5000 km. If the average value of the judgment values recorded every 5000 km exceeds the threshold, a blockage is determined to be occurring in the positive pressure filter and a DTC is stored.
Also, at the same time, a message is displayed on the go to service warning light and engine output is limited. The message on the go to service warning light disappears after clearing the DTC.
| *1 | Fuel Supply Pump Assembly | *2 | Pressurised Fuel Filter |
| *3 | Fuel Filter Element Assembly | *4 | Fuel Tank |
| *5 | To Exhaust Fuel Addition Injector Assembly | *6 | To Common Rail Assembly |
| *7 | Form injector assembly | *8 | Fuel Filter Cap with Element |
|
High Pressure Fuel |
|
Feed Fuel |
|
Suction Fuel |
|
Return Fuel |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
|---|---|---|
| - | The average judgment value of the fuel pressure deviation state every 5000 km exceeds the threshold.
(1 trip detection logic) |
·
Fuel filter element assembly ·
Fuel filter cap with element |
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
P00BB is output.
When P00BB is output, the fuel filter cap with element needs to be replaced. In order to inspect the fuel filter element assembly for blockages, do not perform replacement at this stage.
NEXT
Disconnect the clogging switch connector from the fuel filter element assembly.
Start the engine and warm it up.
Connect a circuit tester to the clogging switch.
Check that the clogging switch does not turn OFF (10 kΩ or higher) when revving the engine up from idling.
If the clogging switch turns OFF, it can be determined that the fuel filter element assembly is becoming clogged.
The clogging switch does not change from ON (below 1Ω) when revving the engine up from idling.
NG
OK
Replace the fuel filter element assembly (See page Engine / Hybrid System>1GD-FTV (FUEL)>FUEL FILTER>REPLACEMENT).
NEXT
Replace the fuel filter cap with element (See page Engine / Hybrid System>1GD-FTV (FUEL)>FUEL FILTER (for Cylinder Block Side)>REPLACEMENT).
NEXT
Bleed the air from the fuel system (See page Engine / Hybrid System>1GD-FTV (FUEL)>FUEL SYSTEM>ON-VEHICLE INSPECTION).
NEXT
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Clear.
Clear the DTCs.
Clearing the DTCs turns off the message in the multi-information display.
NEXT