Home › Engine / Hybrid System › 2TR-FE (FUEL) › FUEL PRESSURE REGULATOR › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053666 2TR-FE FUEL _0260531 FUEL PRESSURE REGULATOR A

2TR-FE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 22030 4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 23280 6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

A355182

a.

Disconnect the purge VSV connector.


b.

Detach the wire harness clamp.


c.

Remove the bolt and disconnect the wire harness clamp bracket.


d.
A355183

Remove the 3 bolts and fuel pressure regulator assembly.


e.
A223392E03
2.976,0.542 3.196,0.749 0.221,0.207 10 *a 1.9,1.175 2.737,0.619 2.737,0.619 2.949,0.619 false

Remove the O-ring from the fuel pressure regulator assembly.

Text in Illustration
*a O-ring