Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL PRESSURE REGULATOR › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053667 1GR-FE FUEL _0260544 FUEL PRESSURE REGULATOR A

1GR-FE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

a.

Discharge the fuel system pressure (See page Engine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 17129 3.REMOVE INTAKE AIR SURGE TANK

a.

Hide 23802B 4.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 23280 5.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.

Disconnect the vacuum hose.


b.
A223049

Remove the 2 bolts and fuel pressure regulator.


c.

Remove the O-ring from the fuel pressure regulator.