Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL PRESSURE PULSATION DAMPER › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053667 1GR-FE FUEL _0260545 FUEL PRESSURE PULSATION DAMPER A

1GR-FE FUEL  FUEL PRESSURE PULSATION DAMPER  REMOVAL  


PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

a.

Discharge the fuel system pressure (See page Engine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 17129 3.REMOVE INTAKE AIR SURGE TANK

a.

Hide 23270 4.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

a.
A223051

Remove the fuel pressure regulator holder.


b.

Pull the fuel pressure pulsation damper out of the fuel delivery pipe.


c.

Remove the O-ring from the fuel pressure pulsation damper.