28800
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
26100
2.REMOVE DIESEL THROTTLE BODY
Remove the diesel throttle body (See page Engine / Hybrid System>5L-E (ENGINE CONTROL)>DIESEL THROTTLE BODY>REMOVAL).
3.REMOVE INJECTION PIPE SET
Using a union nut wrench, loosen the 8 union nuts of the 4 injection pipes.
| *1 | Union Nut Wrench |
| *a | for Injection Nozzle Side |
| *b | for Injection Pump Side |
Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes with 2 lower pipe clamps.
19871
4.REMOVE NO. 1 GLOW PLUG CONNECTOR
23760
5.REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY
Disconnect the fuel hose from the leakage pipe.
Remove the 4 nuts, leakage pipe and 4 ring packing washers.
23600
6.REMOVE NOZZLE HOLDER AND NOZZLE SET
Using SST, remove the 4 injection nozzles, 4 injection nozzle seats and 4 injection nozzle seat gaskets.