Home › Engine / Hybrid System › 5L-E (STARTING) › GLOW PLUG
RM27T0E _51 Engine / Hybrid System _053693 5L-E STARTING _0260725 GLOW PLUG A

5L-E STARTING  GLOW PLUG  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 17705 2.REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY

Hide 12261 4.DISCONNECT VENTILATION HOSE

a.
A225696

Disconnect the ventilation hose.


Hide 19871 5.REMOVE NO. 1 GLOW PLUG CONNECTOR

a.
A224317

Remove the nut, No. 2 glow plug resistor insulator and washer and disconnect the wire harness.


b.

Remove the 4 screw grommets and 4 nuts.


c.

Remove the No. 1 glow plug connector and No. 1 glow plug resistor insulator.


Hide 19850 6.REMOVE GLOW PLUG ASSEMBLY

a.
A224318

Using a 12 mm deep socket wrench, remove the 4 glow plugs.