Home › Engine / Hybrid System › 1GD-FTV (FUEL) › COMMON RAIL › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053670 1GD-FTV FUEL _0260592 COMMON RAIL A

1GD-FTV FUEL  COMMON RAIL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe subassembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
Injector assembly (including shuffling the injector assemblies between the cylinders)
·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly


Supply pump assembly Fuel inlet pipe sub-assembly
·

Common rail assembly

·

Cylinder block sub-assembly

·

Cylinder head sub-assembly

·

Cylinder head gasket

·

Timing chain case assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

Fuel inlet pipe sub-assembly



·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly, clean them with a brush and compressed air.

·

The common rail assembly is a precision instrument. Do not use the common rail assembly if it is struck or dropped.

·

Hold the common rail assembly itself during removal and installation. Do not hold the pressure discharge valve or fuel pressure sensor, etc.

·

Make sure foreign matter does not enter the fuel path.



PROCEDURE

Hide 23810A 1.INSTALL COMMON RAIL ASSEMBLY

a.

Install the common rail assembly with the 2 nuts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


b.

Connect the fuel pressure sensor connector to the common rail assembly.


c.

Attach the wire harness clamp.


Hide 23282D 2.INSTALL NO. 4 FUEL HOSE

a.

Connect the No. 4 fuel hose to the common rail assembly, and slide the clamp to secure it.


Hide 3.TEMPORARILY INSTALL NO. 1 AND NO. 2 INJECTION PIPE SUB-ASSEMBLY

Hide 4.TIGHTEN NO. 1 AND NO. 2 INJECTION PIPE SUB-ASSEMBLY

Hide 5.INSTALL WIRING HARNESS CLAMP BRACKET

Hide 23804C 6.INSTALL FUEL INLET PIPE SUB-ASSEMBLY

Hide 23804D 8.INSTALL NO. 4 FUEL PIPE SUB-ASSEMBLY

Hide 25800 10.INSTALL EGR COOLER ASSEMBLY

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)