23710B
1.INSTALL EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
Install a new No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring, O-ring and No. 3 fuel injector back-up ring to the exhaust fuel addition injector assembly.
Install a new E-ring to the exhaust fuel addition injector assembly.
Install a new gasket and the exhaust fuel addition injector assembly to the No. 1 injector holder.
23695B
2.INSTALL NO. 2 NOZZLE HOLDER CLAMP
Using a T40 "TORX" socket wrench, install the No. 2 nozzle holder clamp with the bolt.
23295C
3.INSTALL INJECTOR HOLDER
Install the injector holder to the No. 1 injector holder with the 2 bolts.
17168
4.INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Install a new gasket and the No. 2 exhaust manifold heat insulator to the No. 1 injector holder with the 3 nuts.
23295D
5.INSTALL NO. 1 INJECTOR HOLDER
Install the No. 1 injector holder to the exhaust manifold with 3 new nuts.
Connect the connector to the exhaust fuel addition injector assembly.
16282
6.CONNECT NO. 5 WATER BY-PASS HOSE
Connect the No. 5 water by-pass hose to the No. 1 injector holder, and slide the clamp to secure the hose.
16281
7.CONNECT NO. 4 WATER BY-PASS HOSE
Connect the No. 4 water by-pass hose to the No. 1 injector holder, and slide the clamp to secure the hose.
12203
8.INSTALL VENTILATION PIPE SUB-ASSEMBLY
23811H
9.INSTALL NO. 1 FUEL PIPE
Connect the No. 1 fuel pipe to the No. 4 fuel pipe.
Install a new gasket and the No. 1 fuel pipe to the cylinder head cover sub-assembly and No. 1 injector holder with the union bolt and bolt.
12601B
10.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
11.BLEED AIR FROM FUEL SYSTEM
12.ADD ENGINE COOLANT
13.INSPECT FOR COOLANT LEAK