Home › Engine / Hybrid System › 5L-E (INTAKE / EXHAUST) › INTAKE MANIFOLD
RM27T0E _51 Engine / Hybrid System _053677 5L-E INTAKE / EXHAUST _0260638 INTAKE MANIFOLD A

5L-E INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 17111 1.INSTALL INTAKE MANIFOLD

a.
A058724E04
1.208,1.469 1.208,1.75 false 1.125,1.771 1.281,1.927 0.156,0.156 10 false *a 2.802,1.396 3.01,1.635 0.208,0.24 10 true *b

Install a new gasket to the cylinder head with the protrusion facing upward.

Text in Illustration
*a Protrusion
*b Upward


b.
A224310E02
0.292,0.438 0.542,0.615 0.25,0.177 10 true *1 2.708,0.469 2.958,0.677 0.25,0.208 10 true *1

Install the intake manifold with the 6 bolts and 2 nuts. Uniformly tighten the bolts and nuts in several steps.

Torque:
24 N*m (240 kgf*cm, 17 ft.*lbf)

Text in Illustration
*1 Nut


c.

Install the wire harness bracket with the bolt.

Torque:
13 N*m (131 kgf*cm, 9 ft.*lbf)


Hide 2.INSTALL INJECTION PIPE

a.

Install the 2 lower clamps to the intake manifold.


b.
A224332

Using a 17 mm union nut wrench, install the 4 injection pipes.

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



c.

Secure the injection pipes by installing the 2 upper pipe clamps and 2 nuts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 26100G 3.INSTALL DIESEL THROTTLE BODY ASSEMBLY

a.

Install a new gasket and the diesel throttle body.


b.

Connect the throttle control motor connector.


c.

Install the bracket with the 2 bolts.

Torque:
13 N*m (131 kgf*cm, 9 ft.*lbf)


d.

Connect the throttle open switch connector.


Hide 17114A 4.INSTALL INTAKE FLANGE

a.

Install a new gasket and the intake flange with the 3 nuts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


b.

Connect the manifold absolute pressure sensor connector.


c.

Install the heater hose bracket with the bolt.

Torque:
14 N*m (138 kgf*cm, 10 ft.*lbf)


d.

Connect the PCV hose.


Hide 17130 5.INSTALL INTAKE PIPE

a.

Install the intake pipe with the 2 bolts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


b.

Tighten the intake pipe clamp.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)