Home › Engine / Hybrid System › 5L-E (FUEL) › FUEL INJECTION NOZZLE › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053668 5L-E FUEL _0260559 FUEL INJECTION NOZZLE A

5L-E FUEL  FUEL INJECTION NOZZLE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NOZZLE HOLDER AND NOZZLE SET

a.
A122389E04
1.833,1.344 2.865,1.74 true 2.906,1.667 3.365,2.115 0.458,0.448 10 true SST

Install 4 new injection nozzle seat gaskets and the 4 injection nozzle seats to the injection nozzle holes of the cylinder head.


b.

Using SST, install the 4 nozzle holder and nozzle sets.

SST
09268-64010  (09268-64020)

Torque:
64 N*m (650 kgf*cm, 47 ft.*lbf)


Hide 23760 2.INSTALL NOZZLE LEAKAGE PIPE ASSEMBLY

a.

Install 4 new ring packing washers and the leakage pipe with the 4 nuts.

Torque:
30 N*m (301 kgf*cm, 22 ft.*lbf)


b.

Connect the fuel hose to the leakage pipe.


Hide 19871 3.INSTALL NO. 1 GLOW PLUG CONNECTOR

Hide 4.INSTALL INJECTION PIPE SET

a.

Install the 2 lower clamps to the intake manifold.


b.
A230069E01
0.085,0.024 0.324,0.190 0.239,0.166 10 *a 0.093,2.456 0.280,2.643 0.187,0.187 10 *b

Install the 4 injection pipes.

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)

Text in Illustration
*a for Injection Nozzle Side
*b for Injection Pump Side

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



c.

Install the 2 upper pipe clamps with the 2 nuts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 26100 5.INSTALL DIESEL THROTTLE BODY

Hide 28800 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 7.BLEED INJECTION PIPE

a.

Move the hand pump on the upper part of the fuel filter up and down and fill the injection pump and fuel system with fuel.


b.

Loosen one of the union nuts (on the nozzle side).


c.

Crank the engine until fuel comes out from the union nut connection (on the nozzle side).


d.

Tighten the union nut.

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



e.

Perform the procedures above for each injection pipe.