28800
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.DRAIN ENGINE COOLANT
53292A
3.REMOVE UPPER RADIATOR SUPPORT SEAL
52129B
4.REMOVE FRONT BUMPER COVER LOWER
51405A
5.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
51450
6.REMOVE REAR ENGINE UNDER COVER ASSEMBLY
7.REMOVE RESONATOR WITH AIR CLEANER CAP
16571C
8.REMOVE NO. 1 RADIATOR HOSE
Detach the clamp and remove the No. 1 radiator hose.
Remove the 2 nuts and hose clamp.
16572D
9.REMOVE NO. 2 RADIATOR HOSE
16470
10.REMOVE RADIATOR RESERVOIR
Disconnect the reservoir hose from the upper side of the radiator tank.
Remove the 3 bolts and radiator reservoir.
16711
11.REMOVE FAN SHROUD
Loosen the 4 nuts holding the fluid coupling fan.
Remove the vane pump V belt and the fan and generator V belt (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>DRIVE BELT>REMOVAL).
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
Be careful not to damage the radiator core.
Remove the fan pulley from the water pump.
12.DISCONNECT COMPRESSOR AND MAGNETIC CLUTCH
88440D
13.REMOVE NO. 2 IDLE PULLEY ASSEMBLY
13568
14.REMOVE TIMING BELT
Remove the timing belt (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>TIMING BELT>REMOVAL).
16100
15.REMOVE WATER PUMP ASSEMBLY
Remove the 6 bolts and tension spring bracket.
Remove the water pump and gasket.