Home › Engine / Hybrid System › 5L-E (LUBRICATION) › LUBRICATION SYSTEM
RM27T0E _51 Engine / Hybrid System _053688 5L-E LUBRICATION _0260692 LUBRICATION SYSTEM G

5L-E LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. CHECK ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloring or thinning.

If the quality is visibly poor, replace the engine oil and oil filter element (See page Engine / Hybrid System>5L-E (LUBRICATION)>OIL AND OIL FILTER>REPLACEMENT).


Hide 2. CHECK ENGINE OIL LEVEL

a.

Warm up the engine and then wait for 5 minutes after turning the engine off. The oil level should be between the low level and full level marks of the dipstick.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not add engine oil above the full level mark.




Hide 3.INSPECT OIL PRESSURE

a.

b.
A227365E02
2.063,0.563 1.938,0.563 1.938,0.563 1.792,0.875 true 2.104,0.49 2.323,0.667 0.219,0.177 10 true *1

Install an oil pressure gauge.

Text in Illustration
*1 Oil Pressure Gauge


c.

Install the vacuum pump oil inlet hose (See page Engine / Hybrid System>5L-E (LUBRICATION)>OIL PRESSURE SWITCH>INSTALLATION).


d.

Install the engine oil level dipstick guide (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>ENGINE UNIT>INSTALLATION).


e.

Warm up the engine.


f.

Measure the oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idling 29 kPa (0.3 kgf/cm2, 4.3 psi) or higher
3000 rpm 294 to 539 kPa (3.0 to 5.5 kgf/cm2, 43 to 78 psi)


If the oil pressure is not as specified, check the oil pump (See page Engine / Hybrid System>5L-E (LUBRICATION)>OIL PUMP>INSPECTION).


g.

Remove the engine oil level dipstick guide (See page Engine / Hybrid System>5L-E (ENGINE MECHANICAL)>ENGINE UNIT>REMOVAL).


h.

Remove the vacuum pump oil inlet hose (See page Engine / Hybrid System>5L-E (LUBRICATION)>OIL PRESSURE SWITCH>REMOVAL).


i.

Remove the oil pressure gauge.