83530
1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
15609
2.INSTALL OIL FILTER BRACKET SUB-ASSEMBLY
17141
3.INSTALL EXHAUST MANIFOLD
17167
4.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
29300B
5.INSTALL VACUUM PUMP OIL OUTLET HOSE
Install the vacuum pump oil outlet hose with the bolt and 2 new gaskets.
The direction of the hose clamp is indicated in the illustration.
6.INSTALL UNION
Clean the threads of the union and apply adhesive to them.
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Install the union to the cylinder block.
29300A
7.INSTALL VACUUM PUMP OIL INLET HOSE
12311
8.INSTALL NO. 1 FRONT ENGINE MOUNTING BRACKET RH
Install the engine mounting bracket with the 4 bolts.
11452
9.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
Apply a light coat of engine oil to a new O-ring.
Install the O-ring to the dipstick guide.
Install the dipstick guide with the 2 bolts.
Install the dipstick.
12315
10.INSTALL NO. 1 FRONT ENGINE MOUNTING BRACKET LH
Install the engine mounting bracket with the 4 bolts.
44443
11.INSTALL PUMP BRACKET
Install the pump bracket with the 3 bolts.
12511
12.INSTALL NO. 1 GENERATOR BRACKET
Install the generator bracket with the 3 bolts.
16261B
13.INSTALL WATER BY-PASS HOSE UNION
Clean the threads of the water by-pass hose union and apply adhesive to them.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the water by-pass hose union.
17111
14.INSTALL INTAKE MANIFOLD
16333
15.INSTALL WATER OUTLET HOUSING
Install a new gasket to the cylinder head.
Install the outlet hosing with the 3 bolts
89422C
16.INSTALL ENGINE COOLANT TEMPERATURE SENSOR
11401G
17.INSTALL CRANKSHAFT POSITION SENSOR
22100
18.INSTALL INJECTION PUMP ASSEMBLY
13613P
19.INSTALL INJECTION PUMP DRIVE PULLEY
19850
20.INSTALL GLOW PLUG ASSEMBLY
23600
21.INSTALL NOZZLE HOLDER & NOZZLE SET
23760
22.INSTALL NOZZLE LEAKAGE PIPE ASSEMBLY
19871
23.INSTALL NO. 1 GLOW PLUG CONNECTOR
24.INSTALL INJECTION PIPE SET
26100
25.INSTALL DIESEL THROTTLE BODY
17114A
26.INSTALL INTAKE FLANGE
13521P
27.INSTALL CRANKSHAFT TIMING PULLEY
28.SET NO. 1 CYLINDER TO TDC/COMPRESSION
13568
29.INSTALL TIMING BELT
11302
30.INSTALL TIMING BELT COVER
13471
31.INSTALL CRANKSHAFT PULLEY
88431
32.INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET
Install the No. 1 compressor mounting bracket with the 4 bolts.
82121
33.INSTALL ENGINE WIRE