28100
1.INSTALL STARTER ASSEMBLY
for Automatic Transmission:
Install the starter assembly with the 2 bolts.
for Manual Transmission:
Temporarily install the starter assembly with bolt.
Temporarily install the clutch flexible hose bracket with the bolt.
| *1 | Clutch Flexible Hose Bracket |
Tighten the 2 bolts.
Connect the starter connector.
Connect the starter wire harness with the nut.
Install the terminal cap.
31470
2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)
51450
3.INSTALL REAR ENGINE UNDER COVER ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).