36100
1.INSTALL TRANSFER ASSEMBLY
33030
2.INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY
Confirm that 2 straight pins are on the manual transmission contact surface of the engine cylinder block before manual transmission installation.
Align the input shaft with the clutch disc and install the transmission unit to the engine.
Install the 8 bolts.
36407
3.CONNECT TRANSFER AND MANUAL TRANSMISSION BREATHER HOSE SUB-ASSEMBLY
Connect the 2 breather hoses to the bracket.
Connect the 3 breather hoses to the transfer adapter and transfer.
4.CONNECT WIRE HARNESS
Connect the 2 connectors and 4 clamps.
17118
5.INSTALL MANIFOLD STAY
12371
6.INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR
Install the mounting insulator and front engine mounting insulator with the 5 bolts.
51204
7.INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
Install the frame crossmember with the 4 bolts and 4 nuts.
Install the 4 bolts to the mounting insulator.
51226A
8.INSTALL FRONT SUSPENSION MEMBER BRACKET LH
Install the member bracket with the 4 bolts.
51225B
9.INSTALL FRONT SUSPENSION MEMBER BRACKET RH
Install the member bracket with the 4 bolts.
28100
10.INSTALL STARTER ASSEMBLY
for 1.4 kW Type:
Install the starter (See page Engine / Hybrid System>2TR-FE (STARTING)>STARTER (for 1.4 kW Type)>INSTALLATION).
for 2.0 kW Type:
Install the starter (See page Engine / Hybrid System>2TR-FE (STARTING)>STARTER (for 2.0 kW Type)>INSTALLATION).
31470
11.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY
Connect the clutch release cylinder with the 2 bolts.
37140
12.INSTALL FRONT PROPELLER SHAFT ASSEMBLY
Install the front propeller shaft (See page Drivetrain>DRIVE SHAFT / PROPELLER SHAFT>FRONT PROPELLER SHAFT ASSEMBLY>INSTALLATION).
37110
13.INSTALL PROPELLER SHAFT ASSEMBLY
Install the propeller shaft (See page Drivetrain>DRIVE SHAFT / PROPELLER SHAFT>PROPELLER SHAFT ASSEMBLY>INSTALLATION).
14.ADD MANUAL TRANSMISSION OIL
36179
15.INSTALL TRANSFER CASE LOWER PROTECTOR
Install the lower protector with the 4 bolts.
33530F
16.INSTALL SHIFT LEVER ASSEMBLY
Apply MP grease to the tip of the shift lever assembly.
|
MP Grease |
Cover the shift lever cap with a cloth.
While pressing down on the shift lever cap, turn it clockwise to install the shift lever assembly.
| *1 | Shift Lever Cap |
| *a | Press down |
| *b | Clockwise |
| *c | Lock |
58286
17.INSTALL NO. 1 SHIFT AND SELECT LEVER BOOT
Install the shift and select lever boot with the 4 screws.
Attach the 2 clips.
58821C
18.INSTALL CONSOLE PANEL SUB-ASSEMBLY
for Manual Transmission: (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Manual Transmission)>INSTALLATION)
w/ Refrigerated Cool Box: (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX (w/ Refrigerated Cool Box)>INSTALLATION
33504F
19.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Install the knob to the shift lever.
20.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).