Home › Engine / Hybrid System › 2TR-FE (STARTING) › STARTER (for 2.0 kW Type) › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053691 2TR-FE STARTING _0260714 STARTER(for 2.0 kW Type) A

2TR-FE STARTING  STARTER(for 2.0 kW Type)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 51450 2.REMOVE REAR ENGINE UNDER COVER ASSEMBLY

Hide 31470 3.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 28100 4.REMOVE STARTER ASSEMBLY

a.
A224313

Remove the terminal cap.


b.

Remove the nut, and then disconnect the starter wire harness.


c.

Disconnect the starter connector.


d.
A224314

for Automatic Transmission:

Remove the 2 bolts and starter assembly.


e.

for Manual Transmission:

i.
U147634E01
2.122,0.262 2.305,0.425 0.184,0.163 10 *1 1.923,0.78 2.025,0.37 2.025,0.37 2.115,0.37 false

Remove the bolt and disconnect the clutch flexible hose bracket.

Text in Illustration
*1 Clutch Flexible Hose Bracket


ii.

Remove the bolt and starter assembly.