28100
1.INSTALL STARTER ASSEMBLY
Install the starter assembly with the 2 bolts and nut.
Connect the starter wire with the nut.
Install the terminal cap.
Connect the starter connector.
31484
2.CONNECT CLUTCH FLEXIBLE HOSE BRACKET
Connect the clutch flexible hose bracket with the bolt.
31470
3.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY
51450
4.INSTALL REAR ENGINE UNDER COVER ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).