1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
51450
2.REMOVE REAR ENGINE UNDER COVER ASSEMBLY
31470
3.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY
31484
4.DISCONNECT CLUTCH FLEXIBLE HOSE BRACKET
Remove the bolt and disconnect the clutch flexible hose bracket.
28100
5.REMOVE STARTER ASSEMBLY
Disconnect the starter connector.
Remove the terminal cap.
Remove the nut and disconnect the starter wire.
Remove the nut, 2 bolts and starter assembly.