1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
33504F
2.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
58821C
3.REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Separate Type)
for Manual Transmission: (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(for Manual Transmission)>REMOVAL)
w/ Refrigerated Cool Box: (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX (w/ Refrigerated Cool Box)>REMOVAL)
58910C
4.REMOVE CONSOLE BOX (for Bench Seat Type)
5.REMOVE FRONT SEAT ASSEMBLY (for Bench Seat Type)
58530J
6.REMOVE CENTER FLOOR CARPET ASSEMBLY (for Bench Seat Type)
Remove the 4 bolts and center floor carpet assembly.
58286
7.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT
Remove the 4 screws, 2 clips and boot.
| *1 | Clip |
| *2 | Screw |
33530F
8.REMOVE SHIFT LEVER ASSEMBLY
Detach the shift lever cap boot from the manual transmission.
Cover the shift lever cap with a cloth.
While pressing down on the shift lever cap, turn it counterclockwise, and then pull to remove the shift lever assembly.
| *1 | Shift Lever Cap |
| *a | Press Down |
| *b | Counterclockwise |
| *c | Pull out |
36179
9.REMOVE TRANSFER CASE LOWER PROTECTOR
Remove the 4 bolts and transfer case lower protector.
10.DRAIN MANUAL TRANSMISSION OIL
17410
11.REMOVE FRONT EXHAUST PIPE ASSEMBLY
Remove the front exhaust pipe (See page Engine / Hybrid System>5L-E (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL).
37140
12.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
Remove the front propeller shaft (See page Drivetrain>DRIVE SHAFT / PROPELLER SHAFT>FRONT PROPELLER SHAFT ASSEMBLY>REMOVAL).
37110
13.REMOVE PROPELLER SHAFT ASSEMBLY
Remove the propeller shaft (See page Drivetrain>DRIVE SHAFT / PROPELLER SHAFT>PROPELLER SHAFT ASSEMBLY>REMOVAL).
14.DISCONNECT WIRE HARNESS
Disconnect the 2 connectors and detach the 4 clamps.
36407
15.REMOVE TRANSFER AND MANUAL TRANSMISSION BREATHER HOSE SUB-ASSEMBLY
Detach the clamp and disconnect the 3 breather hoses from the shift lever retainer and transfer adapter.
Remove the breather hose.
31470
16.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY
Remove the 2 bolts and disconnect the release cylinder.
28100
17.REMOVE STARTER ASSEMBLY
Remove the starter (See page Engine / Hybrid System>5L-E (STARTING)>STARTER>REMOVAL).
51226A
18.REMOVE FRONT SUSPENSION MEMBER BRACKET LH
Remove the 4 bolts and member bracket.
51225B
19.REMOVE FRONT SUSPENSION MEMBER BRACKET RH
Remove the 4 bolts and member bracket.
51204
20.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
Support the rear side of the transmission with a support stand.
Remove the 4 bolts of the rear No. 1 engine mounting insulator.
Remove the 4 bolts, 4 nuts and frame crossmember.
12371
21.REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR
Remove the 4 bolts and engine mounting insulator.
33119
22.REMOVE STIFFENER PLATE LH
Remove the 4 bolts and stiffener plate.
33118
23.REMOVE STIFFENER PLATE RH
Remove the 4 bolts and stiffener plate.
33030
24.REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY
Using a transmission jack, support the transmission.
Remove the support stand from the transmission.
Remove the 4 bolts and transmission.
36100
25.REMOVE TRANSFER ASSEMBLY