Home › Engine / Hybrid System › 5L-E (STARTING) › GLOW PLUG
RM27T0E _51 Engine / Hybrid System _053693 5L-E STARTING _0260725 GLOW PLUG A

5L-E STARTING  GLOW PLUG  INSTALLATION  


PROCEDURE

Hide 19850 1.INSTALL GLOW PLUG ASSEMBLY

a.

Using a 12 mm deep socket wrench, install the 4 glow plugs.

Torque:
13 N*m (130 kgf*cm, 10 ft.*lbf)


Hide 19871 2.INSTALL NO. 1 GLOW PLUG CONNECTOR

a.

Install the No. 1 glow plug resistor insulator and No. 1 glow plug connector.


b.
A224319E01
0.617,1.501 0.791,1.661 0.174,0.159 10 *1 0.617,1.88 0.791,2.039 0.174,0.159 10 *3 0.617,2.859 0.791,3.019 0.174,0.159 10 *4 1.61,1.685 1.784,1.844 0.174,0.159 10 *2 1.916,2.12 2.090,2.280 0.174,0.159 10 *5 1.916,2.538 2.090,2.697 0.174,0.159 10 *6 2.842,2.529 3.015,2.689 0.174,0.159 10 *7 1.11,1.689 0.905,1.586 0.905,1.586 0.818,1.586 false 1.11,2.069 0.905,1.966 0.905,1.966 0.818,1.966 false 1.313,1.874 1.517,1.771 1.517,1.771 1.605,1.771 false 1.153,2.609 0.9,2.954 0.9,2.954 0.818,2.954 false 2.362,2.083 2.183,2.209 2.183,2.209 2.117,2.209 false 2.383,2.486 2.183,2.626 2.183,2.626 2.117,2.626 false 2.562,2.769 2.762,2.63 2.762,2.63 2.828,2.63 false

Install the glow plug connector with the 4 nuts. Uniformly tighten the nuts.

Torque:
1.0 N*m (10 kgf*cm, 9 in.*lbf)

Text in Illustration
*1 Nut
*2 Washer
*3 No. 2 Glow Plug Resistor Insulator
*4 Engine Wire
*5 No. 1 Glow Plug Connector
*6 No. 1 Glow Plug Resistor Insulator
*7 Bolt


c.

Install the 4 screw grommets.


d.

Connect the engine wire and install the No. 2 glow plug resistor insulator and washer with the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 12261 3.CONNECT VENTILATION HOSE

a.

Connect the ventilation hose.


Hide 17705 5.INSTALL RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).