Home › Engine / Hybrid System › 1KD-FTV (STARTING) › GLOW PLUG › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053694 1KD-FTV STARTING _0260730 GLOW PLUG G

1KD-FTV STARTING  GLOW PLUG  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK GLOW PLUG

a.

Remove the No. 1 glow plug connector (See page Engine / Hybrid System>1KD-FTV (STARTING)>GLOW PLUG>REMOVAL).


b.
A111828E05
1.06,1.263 1.233,1.419 0.172,0.157 10 *1 1.245,1.358 1.349,1.358 1.349,1.358 2.125,1.739 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Specified Condition
Glow plug terminal - Body ground 0.15 to 1.75 Ω


Text in Illustration
*1 Screw Grommet

If the result is not as specified, replace the glow plug.

NOTICE:
·

Be careful not to damage the glow plug pipes, as this may cause an open circuit or shorten the life of the glow plugs.

·

Do not allow oil or gasoline to contact the glow plug when cleaning it.

·

Clean any oil on the terminal and Bakelite washer with a dry cloth.

·

Do not apply more than 11 V to the glow plug, as this may cause an open circuit.




c.

Install the No. 1 glow plug connector (See page Engine / Hybrid System>1KD-FTV (STARTING)>GLOW PLUG>INSTALLATION).