Home › Engine / Hybrid System › 1KD-FTV (STARTING) › GLOW PLUG › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053694 1KD-FTV STARTING _0260730 GLOW PLUG A

1KD-FTV STARTING  GLOW PLUG  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 25800 2.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY (w/ EGR System)

a.

Remove the electric EGR control valve (See page Engine / Hybrid System>1KD-FTV (EMISSION CONTROL)>EGR VALVE>REMOVAL).


Hide 87245A 3.DISCONNECT INLET HEATER WATER HOSE (w/o EGR System)

Hide 25709E 4.DISCONNECT NO. 4 VACUUM TRANSMITTING PIPE SUB-ASSEMBLY (w/o EGR System)

Hide 17113E 5.REMOVE NO. 1 INTAKE PIPE (w/o EGR System)

Hide 6.REMOVE THROTTLE BODY BRACKET (w/o EGR System)

a.
A230166

Disconnect the vacuum hose.


b.

Remove the bolt and gas filter with gas filter bracket.


c.

Remove the 2 bolts and throttle body bracket.


Hide 7.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY (w/o EGR System)

Hide 17871A 8.REMOVE AIR CONNECTOR STAY (w/o EGR System)

a.
A230167

Remove the 3 bolts and air connector stay.


Hide 9.DISCONNECT ENGINE WIRE (w/o EGR System)

a.
A225769

for LHD:

Remove the 2 bolts and disconnect the clamp and engine wire.


b.
A225770

for RHD:

Remove the bolt and disconnect the engine wire.


Hide 26100G 10.REMOVE INTAKE AIR CONNECTOR WITH DIESEL THROTTLE BODY ASSEMBLY (w/o EGR System)

a.
A230087

Disconnect the throttle position sensor connector.


b.
A230165

Remove the 3 bolts, intake air connector with diesel throttle and gasket.


Hide 12.REMOVE NO. 2 MANIFOLD STAY

a.
A222609

Remove the bolt and No. 2 manifold stay.


Hide 19871 13.REMOVE NO. 1 GLOW PLUG CONNECTOR

A222606

a.

Remove the screw grommet and nut and disconnect the wire harness from the No. 1 glow plug connector.


b.

Remove the 4 screw grommets, 4 nuts and No. 1 glow plug connector.


Hide 17135A 14.REMOVE NO. 1 INTAKE MANIFOLD INSULATOR

A222607

Hide 19850 15.REMOVE GLOW PLUG

A222608

a.

Remove the 4 glow plugs.