Home › Engine / Hybrid System › 1KD-FTV (STARTING) › STARTER (for 2.7 kW Type) › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053694 1KD-FTV STARTING _0260732 STARTER(for 2.7 kW Type) A

1KD-FTV STARTING  STARTER(for 2.7 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the bolt and nut.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


b.

Connect the starter wire with the nut.

Torque:
21 N*m (215 kgf*cm, 16 ft.*lbf)


c.

Connect the starter connector.


d.

Install the terminal cap.


Hide 31470 2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 53737A 4.INSTALL FRONT NO. 1 FENDER APRON TO FRAME SEAL LH

a.

Install the frame seal with the 5 clips.


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).