Home › Engine / Hybrid System › 1KD-FTV (STARTING) › STARTER (for 2.7 kW Type) › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053694 1KD-FTV STARTING _0260732 STARTER(for 2.7 kW Type) A

1KD-FTV STARTING  STARTER(for 2.7 kW Type)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 53737A 2.REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL LH

a.

Remove the 5 clips and frame seal.


Hide 51450 3.REMOVE REAR ENGINE UNDER COVER ASSEMBLY

Hide 28100 5.REMOVE STARTER ASSEMBLY

a.

Remove the terminal cap.


b.
A224848

Remove the nut and disconnect the starter wire.


c.

Disconnect the starter connector.


d.
A223731

Remove the bolt, nut and starter assembly.